Alright Im doing a motorbuild and wondering if there are any suggestions on what to do or what not to do, what I need and what I dont.

Heres what Im doing: S5 N/A rotors into a S4 T2 housings. Im getting the whole S5 assembly, ie. rotors eccentric shaft counterbalance. Is this all I need to do the build? I need the T2 housing to do a bridge port on, and the S5 rotors for the high compression. I plan on a Bridgeport with an ITB setup. Pretty much for track use only. Probably a lot of hard mile put on motor, So if there are any suggestions on the build please let me know. Will the assembly fit in just fine or what? My first build so every little bit helps. What type of seals do you suggest. I was leaning towards the stock, being its just an N/A motor, but due to the high revving it will sustain under racing, If someone suggests something other please do tell. Have any of you done this type of build and do you have a write up on it or does anyone know where I can find a writeup on it. Will the different series rotors affect the life of the build? Thanks

-Nick

 

S5 rotors and rear counterweight, i dont remember if you need the front one or not.

 

I believe Im getting both. I would assume I needed it, to totally balance that assembly. I dunno maybe Im wrong. If anyone knows please post