S5 intake manifold swap... yet another question, (I searched guys... REALLY!)
#1
Wait................What?
Thread Starter
Join Date: Apr 2003
Location: Raleigh/Cary, NC - USA
Posts: 521
Likes: 0
Received 0 Likes
on
0 Posts
S5 intake manifold swap... yet another question, (I searched guys... REALLY!)
Simple question. I have searched.
What, if any, modifications are needed to get the S5 LIM to fit the S4 block. I have searched about the S5 intake swap... but did not find this answer specifically. If the answer is out there, please just ignore this thread then if you please.
Nothing about getting the 6 ports to work... JUST the fitment of the manifold.
What, if any, modifications are needed to get the S5 LIM to fit the S4 block. I have searched about the S5 intake swap... but did not find this answer specifically. If the answer is out there, please just ignore this thread then if you please.
Nothing about getting the 6 ports to work... JUST the fitment of the manifold.
Last edited by poor_red_neck; 08-01-04 at 08:26 PM.
#2
Mountain Rotary Mod
Join Date: Nov 2003
Location: Freaking Poland!!
Posts: 2,411
Likes: 0
Received 0 Likes
on
0 Posts
The S5 LIM will bolt right up the S4 block without a problem. I have a S4 block in my S5 car and i'm using all the S5 engine parts. If you're doing a S4 swap into an S5 then go to http://www.rotaryresurrection.com and read about the swap in the tech section.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM