Awhile ago i was going through all my connections in the engine bay making sure they were ok, the Crank Angle Sensor was badly worn after a couple wiggles the connector broke right off of the harness, now its my last bit of electrical before i can startup my build. before i make a new connection can somebody with a S5 check their CAS and confirm which wires meet which wires.

My Sensor has Red, Light Green, White/Black or /blue and what looks an all white
Whereas the harness has Red , Dark Green, Dark Blue and a white wire

Im guessing red+red, Green+Green, White+White, Blue+White/Black or /blue. But any conformation would be greatly appreciated

Thank you so much for the help

 

For future reference, S4 and S5 both use the same N326 CAS and are wired the same as follows:

Green>Green
Red>Red
White>White
Blue>Blue

You can use any connector you want for these connections. But given the location, I'd strongly suggest a sealed connector such as the Delphi Weatherpack or Metripack ones for long term reliability