s4 vert idle issues after r+r
Thread Starter
707
Joined: May 2004
Posts: 854
Likes: 0
From: Santa Rosa Ca
s4 vert idle issues after r+r
ok i was trying to figure out a problem with another rx7 and since my ran great i used a few parts from it. i took out the ecu, afm and leading coil to try in the other car when i went to put everything back into my vert it doesnt want to idle
it doesnt jump around to much but doesnt seem to smooth on the low idle at all than it just dies.. runs fine when driving just not idle.
all i did was remove and replace the ecu, afm and leading coil.
if somethings running right, dont touch it bottom line
it doesnt jump around to much but doesnt seem to smooth on the low idle at all than it just dies.. runs fine when driving just not idle.
all i did was remove and replace the ecu, afm and leading coil.
if somethings running right, dont touch it bottom line
Jesus is the Messiah
Joined: May 2003
Posts: 4,848
Likes: 0
From: Silver Spring, MD
Are you sure all the wires are in nice and tight? Try jiggling them while the car is running and see if the RPM or sound changes, that might clue you in to a loose connection.
How long has it sat before it last ran right?
How long has it sat before it last ran right?
Thread
Thread Starter
Forum
Replies
Last Post
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
The Shaolin
2nd Generation Specific (1986-1992)
9
Sep 14, 2015 07:50 PM