fc1990

alright i just swapped in a s4 trany into my s5 fc. i noticed that my tranny mount was different and the brace that holds the trany up is different too. now my question is are the braces and the mounts different . cause right now im lost on what to do. btw the s4 tranny i have has 2 bolts that hold it to the tranny is that right...

Black91n/a

You need an S4 crossmember.

fc1990

so the mounts are different then . alright well if thats it than i can probly find that somewhere . im just making sure the mounts are different .

FC3Sdrift

iTrader: (5)

the actual mounts are the same the tranny cradle and crossmember are different, you could get them both new from mazda for 80 or so

Turbonut

iTrader: (1)

Make certain the 2 trans mounts are good and not collapsed. If not, it will knock out the bushing in the crossmember if the mounts have settled.

fc1990

no the crossmember i need is different . my car is a s5 with a s4 trany. now i was looking at my broken s5 trany and the mounts go on the sides of the trany and it has 4 bolts to hold the mount to the trany not the 2 my s4 trany dose. so dose this mean all i need is a s4 crossmember or dose it mean i need more.

Turbonut

iTrader: (1)

Crossmember from the S4, either Turbo or N/A as they are different. When you use the S4 crossmember it will bolt correctly to the frame and existing S4 trans mounts.

fc1990

what is the difference between the N/A and the Turbo S4 crossmember.