S4/s5 Lim's
#1
King of the Loop
Thread Starter
S4/s5 Lim's
Ok I think i posted this a while ago but I cant rememebr what was replied and cant find it so Ill ask again. I know for sure I have a s5 block and s4 UIM. But how do I know what my LIM is?
I need to know so I know if I need to port match my s5 manifolds before installing them.
WIll and s4 LIM even fit on an s5 block?
I need to know so I know if I need to port match my s5 manifolds before installing them.
WIll and s4 LIM even fit on an s5 block?
#2
DON'T PANIC
Join Date: Feb 2004
Location: Old Hickory, TN
Posts: 194
Likes: 0
Received 0 Likes
on
0 Posts
You can tell by the bolt pattern on the top where it bolts to the extention (or, on s5 cars, the VDI) manifold. On s4 cars the bolts are equaly spaced, and on s5 cars the bolt closest to the firewall is about a half inch farther away than the others.
#4
R.I.P. Monte Negro FD
iTrader: (1)
Join Date: Feb 2004
Location: NYC & Davie, FL
Posts: 1,099
Likes: 0
Received 0 Likes
on
0 Posts
yo brooklyn, call tony from T&R racing in queens. 718-725-0179 or visit onlinr www.rx7s.com
#5
DON'T PANIC
Join Date: Feb 2004
Location: Old Hickory, TN
Posts: 194
Likes: 0
Received 0 Likes
on
0 Posts
I driving a red '88 vert with fender mirrors. Don't get out toward rivergate much, usually out toward Lebanon or Donelson. Always good to hear of more rotorheads in the area.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM