I went to mock up my interior last night and found the fiberglass bin support piece wont fit in between the trim pieces that snap into the sides of the car below the B pillar. Maybe the Bin supports and the trim are from diffrent Series?


Ive sourced parts from different gens and i cant tell if my trim or bin support are S4 or S5.

Any insight guys?

 

The only difference between the S4 supports and the S5 bin supports is the holes drilled for the screws and that the US spec S5 cars have a slightly wider seat belt section so the bin support is trimmed accordingly again, for the S5 US spec models.

 

my bin support is too wide at its widest point, if i were to trim about 1/2 inch off of each one it would fit fine- id rather get the correct parts and go that route though

 

why? its gonna be covered with carpet anyway.

 

right, but on the other hand if i have the wrong trim it will possibly cause other fitment issues.
ill snap a pic tonight and maybe someone can identify it.

 

i have a tenth ae s4 and i used an s5 bin support an there is a slight differance it shouldnt matter with the trim but there will be a gap between the inner wheel well right behind the b-pillar

 

Too bad I tossed my extra bin support I had...

 

so i think ive got the opposite, S5 trim and an S4 bin support so there's a slight overlap

 

Yep, time to get out the Jig saw

 

if you really think you have s4 supports just track down some s5 ones, the bin supports are pretty cheap since every drifter wants to have stripped interior

 

yeah, maybe the bins but I'm having bitch of a time finding a dash that was removed with any care

i wish i thought it through about an interior before i pulled all my dash harness and heater core etc out- It's not gonna be fun to reinstall everything.