I'm working on tracing every wire in the FC and have got it 99% done except for one single wire.

It is in connector FE-05. There are 4 versions of FE-05, a single pin (Turbo II), 3-pin (Automatics), 4-pin (Manual trans cars) and a 6-pin (any car with ABS). What I need to trace is the Yellow/Blue wire (top row, middle pin) in the ABS version of FE-05. On the Front side of this connection, it is Yellow/Blue (Y/L). For the Engine side, automatics don't have a wire here, and manuals have another Yellow/Blue wire.

If you have a S4 with ABS, could you do me a big favor and trace these wires? I've identified the manufacturers of EVERY connector throughout the whole car and this is the ONLY wire preventing me from building brand new harnesses for our cars.

thanks,
Travis

 

Temporarily stickied.

 

alright im gunna try to help, i have a s4 with abs which i deleted, but i still have the abs computer and wiring. i dont have a manual, so could you post a picture of what connector, or a wiaring diagram. I'd be happy to help i just want to make sure i give you the correct information.

 

I have an s4, sadly I can't help as I don't have ABS.

I would just like to offer my support, and know that I will probably be one of your customers for a new wiring harness for my car!

I hate my wiring harness with a fiery burning passion because it does nothing but ruin my otherwise good car. no damn passenger window, and no damn blower motor despite ripping out the whole dashboard and checking all the wires and connectors and components...
If only I could replace the whole harness! that would solve all my electrical "gremlins"

best of luck to you

 

Unfortunately, I don't have a picture of this connector or where it is exactly located, due to the FSM smearing that area into an illegible mass. To get you there, follow the starter's trigger wire (Black/White) back to where it goes and you'll always end up at FE-05 on manuals, inhibitor switch (E-14) and then FE-05 on automatics.

It is a Six pin connector that uses 1/4" spade tab connectors and should look nearly identical to the windshield wiper motor connector (Location: firewall, passenger side, also uses 1/4" spade tabs)

 

Unsticking. Free bump.