rx7 motor port
02-04-08, 10:14 PM
#1
Junior Member
Thread Starter
Join Date: Nov 2007
Location: San Diego, California, USA
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
rx7 motor port
Alright so rather then swaping a turbo motor into my FC i decided i rather do a port job on my N/A motor. Any ideas on what port i should do? I want to do the biggest "baddest" port possible. 
I'm looking to do have a J port done. Anyways. . . . I was thinking about having someone do it for me for about 250 bucks but i wanted to make an attempt to do it myself. I found these templates:
http://www.pineappleracing.com/index...arch=GO&Page=1
But I'm still unsure of what port I should do and how exactly to do it. What special tools would i need to take apart the housing with. And what tool would be best when i make the cuts in the housing? Any tutorials online for this?
I'm looking to do have a J port done. Anyways. . . . I was thinking about having someone do it for me for about 250 bucks but i wanted to make an attempt to do it myself. I found these templates:http://www.pineappleracing.com/index...arch=GO&Page=1
But I'm still unsure of what port I should do and how exactly to do it. What special tools would i need to take apart the housing with. And what tool would be best when i make the cuts in the housing? Any tutorials online for this?
02-05-08, 09:10 AM
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
If you want the "baddest" port around, cut the foreplay and peripheral port the thing. Keep in mind that you'll need to build your own intake manifold, exhaust, and you'll need a full standalone to control it.
Thread
Thread Starter
Forum
Replies
Last Post
Azevedo
Other Engine Conversions - non V-8
26
03-01-19 09:19 PM
