RX-8 Stationary Gear into S5 ?
#1
RX-8 Stationary Gear into S5 ?
I'm sure someone did this before, I want to do it to mine, but for the front, Mazdatrix's web site said :
"Does fit all 13B, hardened multi-window bearing, set screw retention. Bearing clearance must be checked/modified if using this with any RX-7 13B shaft."
Anybody know why is that? The reason I ask is I thought the stationary bearing is the same size for all 13b ?
and for the rear I searched and found some topic saying that the rear's oil galley(the hole?) does not line up correctly and need to dremel it to fit?
Thx
"Does fit all 13B, hardened multi-window bearing, set screw retention. Bearing clearance must be checked/modified if using this with any RX-7 13B shaft."
Anybody know why is that? The reason I ask is I thought the stationary bearing is the same size for all 13b ?
and for the rear I searched and found some topic saying that the rear's oil galley(the hole?) does not line up correctly and need to dremel it to fit?
Thx
#2
NASA-MW ST4
iTrader: (7)
So, I have RX8 gears and they installed without any problems. My oil gallery did have to be modified to line up correctly, but I know a guy's who didn't have to be modified. Not confirmed but we think this was because his was a 6 port hi power bearing and mine might have been a 4 port low power front gear.
Thread
Thread Starter
Forum
Replies
Last Post
MILOS7
3rd Generation Specific (1993-2002)
2
10-09-15 02:19 AM