I was curious as to how well Atkins Apex seals would hold up on a streetported turboed s4 na, it was streetported by rotaryresurrection. If I did it with a cheap setup I would only be running 6psi (safc, injectors, fuelpump). But with a nice setup 12+ psi.

 

the 3mm or 2mm?

 

2mm

 

i dont see any problems with running them but you could call atkins and ask them what they think

 

I know a guy running atkins 2mm on a turbo half-bridge, so theres no reason it shouldn't work with a streetport.

 

But since my car would be an n/a turbo wouldnt it be putting more stress on the seals since it has a higher compression 9.4:1 , where turbo is 8.5:1 or 9.0:1

 

They're fine. Guess what seals I run...

 

yes, listen to Aaron

 

im running s4 n/a rotors in my streetported Turbo II motor and boosting 12psi its fine. (so far)

 

One thing I'd defintely have to fix is a small oil leak on the oil pan it looks like, is this common on rx7s ? It's right on the corner where the exhaust manifold and omp is at. I do know one bolt on my oil pan isnt there because it was broken inside..but i dont know if its in this same area. I did replace the gasket and use sealer...so maybe the pan is bad ?