hey I am working on my electropnuematic 5/6ports and need help with something. See my rmp switch is from a msd setup, the instructions tell me to connect the rpm reading wire to the msd unit. Since i dont have a msd unit to hook it too where should i attach it. I assume i can attach it to the same sensor the tachometer reads but i dont have a clue where this is or how to find it without removing my cluster. I'd appreciate any help you can give me.

 

well you have an FC right? on my 87 near lke allmost under the clutch master cylander, but nearer to the fender, is bunch of wiring and couple of conectors and 1 of them is a small black round single conector, female end. that is an extra trailing coil signal u can use for rpm switch.

 

Thanks a bunch. Is the quote above your avatar sarcasm?

 

yes of course its a BIG joke , u should see my car lol, i have HONDA simbol on the back its on there as a joke cause i see all these hondas with fake type R badge or some other combo of letters like SI-R which doesnt exist in USA, its crazy any ricer that comes up behind me gets angry and allways wants to **** with me, everywhere i go people try to race me! its funny!!!



now if anyone else likes honda then they can like it, its not for me i like RWD and cars that handle and i can DRIFT!,