2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

rough idle

Thread Tools
 
Search this Thread
 
Old Jul 6, 2002 | 08:44 PM
  #1  
budracin's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Jun 2002
Posts: 9
Likes: 0
From: tx
rough idle

i have an 87se and just did a top end rebuild, new injectors, manifold, the whole top end you might say. But now i have a bad engine vibration at idle. under excelleration in park it revs up good, no vibs, but just lacks quick pedal response like before. seems like a foul plug or something. cant find any auto parts dealer who has plugs for this car also (any advice)...wondering if this could be the air/fuel mixture.
Reply
Old Jul 6, 2002 | 08:47 PM
  #2  
Senior Member
Tenured Member 10 Years
 
Joined: Apr 2001
Posts: 364
Likes: 0
From: Omaha,Nebraska,USA
check for vac leaks... try to find spark plugs
check TPS... make sure it's set right... did you mess with the MAF ?
Reply
Old Jul 9, 2002 | 05:28 PM
  #3  
budracin's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Jun 2002
Posts: 9
Likes: 0
From: tx
ok, put in the new plugs, but the rough idle is still there. the TPS is set right, and I never messed with the MAF
Reply
Old Jul 9, 2002 | 10:32 PM
  #4  
jimmyv13's Avatar
Round&Round not Up&Down
Tenured Member 15 Years
 
Joined: Aug 2001
Posts: 2,805
Likes: 0
From: West Bloomfield, MI
Vac leak(very likely)
Improperly seated injector(not likely)

If you have time and patience, take it all apart and put it back together again, slowly. Make sure all vac lines are fully seated....
Reply
Old Jul 10, 2002 | 03:58 AM
  #5  
309's Avatar
309
n()m{^^}m()n
Tenured Member 10 Years
 
Joined: May 2001
Posts: 190
Likes: 0
From: NY
whats MAF and where is it located? and y not?
Reply
Old Jul 10, 2002 | 08:30 AM
  #6  
jimmyv13's Avatar
Round&Round not Up&Down
Tenured Member 15 Years
 
Joined: Aug 2001
Posts: 2,805
Likes: 0
From: West Bloomfield, MI
Originally posted by 309
whats MAF and where is it located?
MAF = Mass Air Flow, located right behind the airbox or cone filter which ever you have.

and y not?
Y not what?
Reply
Old Jul 19, 2002 | 06:42 AM
  #7  
budracin's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Jun 2002
Posts: 9
Likes: 0
From: tx
i tore it back down and did find that my intake gasket had a bad spot so it was replaced. it improved the vibration dramatically..still shakes a little at idle but not half as bad as before. When i took it out on the road it seemed to still lack the power it should. I put new plugs in (T&L). All the compression is good. but just cant get that giddy-up & go it should have??????????????
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
kuuva86
2nd Generation Specific (1986-1992)
2
Sep 28, 2015 05:42 AM
Jmolina0163
1st Generation Specific (1979-1985)
19
Sep 25, 2015 06:06 PM
firzen
2nd Generation Specific (1986-1992)
9
Sep 15, 2015 12:04 PM
RotaryBobby
1st Generation Specific (1979-1985)
1
Sep 10, 2015 01:33 PM




All times are GMT -5. The time now is 12:04 PM.