Net Seven

iTrader: (5)

I pressed in the rotor bearing and its a little off with the tooth. I was wondering if it has to be totally in the spot or if the way I have it is fine. It went in so tight I dont see it ever moving in there. What do you guys recommend? Here is a picture of what im talking about.

SureShot

Well - it's not perfect, but I'd leave it rather than risk damaging the bearing to move it.

Mr. Gadget

It should be fine.

gambone

iTrader: (3)

A trik to get good aline ment , use a squair (rite spelling?) and mark a line down the side for a guide

Mr. Gadget

Exactly, also chill the bearing to 32-35 degrees F. while keeping the rotor at room temp or above. They slide right in to the correct alignment following these easy tips.

HAILERS

DryIce is available at some SuperMarkets like Albertsons. Pack the bearing in that prior to the install.

hpram99

or just put it in a dry freezer (and wipe off any possible mosture when you take it out), and bake the rotor in an oven.

Net Seven

iTrader: (5)

With the bearing chilled cold and the rotor hot how easy does it slide in?