replace stationary gear?
#1
Junior Member
Thread Starter
Join Date: Jan 2006
Location: so cal
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
replace stationary gear?
there is some wear on my stationary gears across some of the teeth. Its enough to barely catch my finger nail. Should they be replaced?
#2
aim** JI II IM IM Y
Join Date: May 2005
Location: 90703 cerritos california
Posts: 495
Likes: 0
Received 0 Likes
on
0 Posts
well that desicion is all on u.
if u think that its still usable then reuse it.
if it were me, id replace em. small groovings can later turn in to big groovings. better safe than sorry right?
if u think that its still usable then reuse it.
if it were me, id replace em. small groovings can later turn in to big groovings. better safe than sorry right?
#3
Lives on the Forum
It depends...
It is on the "front" side or the "back" side of the gear?
If it's on the front face, then it should be replaced.
Is this a turbo or a non-turbo?
Highly modified?
If we're talking about a relatively low-powered FC, I'd be more worried about what's causing the premature wear???
-Ted
It is on the "front" side or the "back" side of the gear?
If it's on the front face, then it should be replaced.
Is this a turbo or a non-turbo?
Highly modified?
If we're talking about a relatively low-powered FC, I'd be more worried about what's causing the premature wear???
-Ted
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM