removing waterpump housing
#1
Full Member
Thread Starter
Join Date: Sep 2004
Location: Kansas City MO
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
removing waterpump housing
Okay so I am getting ready to remove my waterpump housing to replace it (I snapped a bolt off in the filler neck and failed at drilling it out) So I was wondering when i put everything back together should I put some sort of grease on all the threads to prevent any rust like anti seize or something? Also on the housing to block gasket should I put a lil bit of gasket sealer on each side?
#2
Nurse I need 1300cc's NOW
a little bit of anit sieze couldnt hurt
i use 3m wetherstrip adhesive (yellow) on the gasket an apply it to housiing . then i put some rtv on the other side of the gasket.
i use 3m wetherstrip adhesive (yellow) on the gasket an apply it to housiing . then i put some rtv on the other side of the gasket.
Thread
Thread Starter
Forum
Replies
Last Post
cdn
2nd Generation Specific (1986-1992)
14
09-10-15 06:23 AM
rotor_veux
2nd Generation Specific (1986-1992)
7
08-31-15 07:49 PM
cdn
2nd Generation Non-Technical and pictures
0
08-11-15 08:59 PM