Just had a quick question, i searced but couldnt find any real good direction.

I am planning on removing my BAC, blocking it off wont be a problem, i'll make a plate for that, secondly... There is a coolant hose that runs from the back of the waterpump housing, to the front of the BAC... out the back of the BAC and to the back of the throttle body, thru the secondary throttle plate thermo wax, that back out and goes somewhere under the upper intake manifold.. (i assume back into the block correct?

OK: my question, from the back of the waterpump housing, can i run the hose STRAIT to the other connection point on the top of the engine housing under the UIM?

Also, i noticed a rather large vacume hose running from the top of the BAC, over the dynamic chamber and connects to under the Trottle intake ducting (large black tube)... what shall i do with that?

Any other info would be great

P.S, i've got an 86 n/a... with alot of other stuff removed, the spider vacume thing is next... just gotta figure out what to block off... than after that the EGR valve goes..

-Markus

"Just removing stuff i dont need i suppose"

 

OK: my question, from the back of the waterpump housing, can i run the hose STRAIT to the other connection point on the top of the engine housing under the UIM?

Also, i noticed a rather large vacume hose running from the top of the BAC, over the dynamic chamber and connects to under the Trottle intake ducting (large black tube)... what shall i do with that?

1 YES
2 I blocked it off with tons of RTV :-/

 

I removed my thermo wax and ran the line from the pump straight to the engine block.

 

BAC?