Removed UIM wonder what those holes are
11-02-07, 12:40 AM
#1
OMG ITS A TRIANGLE!
Thread Starter
Join Date: Jan 2006
Location: San Francisco
Posts: 376
Likes: 0
Received 0 Likes
on
0 Posts
Removed UIM wonder what those holes are
ok so i removed my UIM and everything else to be swapped onto my new engine.
the UIM ( one hole is covered i think thats normal)
New Engine with the holes plugged
old engine and the holes are open
so i was wonder what those holes are and if its ok to leave it blocked?
thanks, William
the UIM ( one hole is covered i think thats normal)
New Engine with the holes plugged
old engine and the holes are open
so i was wonder what those holes are and if its ok to leave it blocked?
thanks, William
11-02-07, 08:01 AM
#6
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
The rotor housings with the water passages *plugged* are non turbo rotor housings....most likely.
If you drill out the rear coolant passage, then where will you install the o'ring to keep the water from leaking out? There's no place for the o'ring to seat on the non turbo housing.
If you drill out the rear coolant passage, then where will you install the o'ring to keep the water from leaking out? There's no place for the o'ring to seat on the non turbo housing.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM