remove solenoid valve error codes
Thread Starter
Rotary Enthusiast
Joined: May 2005
Posts: 1,135
Likes: 0
From: Vernon, BC
remove solenoid valve error codes
MAN I just got a scare.
New rebuild in and topped with fluids. turn the key to check for codes, gives me SEVEN of them! anyways, recorded them, and theyre because of all the emmissions stuff. Pressure reg control, relief, switch, port air, BAC, and AWS. dont care! anyways, just wondering if I can ground out some of the solenoid plugs or anything to remove the codes? dont care terribly but itd be nice when I actually AM checking for codes to not have to go through those 7 every time.
New rebuild in and topped with fluids. turn the key to check for codes, gives me SEVEN of them! anyways, recorded them, and theyre because of all the emmissions stuff. Pressure reg control, relief, switch, port air, BAC, and AWS. dont care! anyways, just wondering if I can ground out some of the solenoid plugs or anything to remove the codes? dont care terribly but itd be nice when I actually AM checking for codes to not have to go through those 7 every time.
I'm a boost creep...
Joined: Jan 2002
Posts: 15,608
Likes: 8
From: Auckland, New Zealand
Measure the resistance of each solenoid and poke a resistor of equal or similar value in the solenoid plug's terminals. This will trick the ECU into thinking the solenoids are still there.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
Oct 9, 2015 10:05 PM