Relocating the front plate
#1
Rotary Enthusiast
Thread Starter
Join Date: Jan 2007
Location: California
Posts: 1,026
Likes: 0
Received 0 Likes
on
0 Posts
Relocating the front plate
any suggestion and any idea that can do? i want to put it down to the side of the front bumper but doesn't seem to do it.
thanks
thanks
#2
Slowpoke
iTrader: (3)
on my s13 i drill a hole on the front bumper where i want it..
1.Make 2 holes for the screws to hold the plate
2.Use some machine screws with washers. Put them on the inside of the bumper sticking out..
3.Then on the outside, put a lockwasher and nut to secure them. Make sure you have enough length left on the screw.
4. you will put the plate on.
5. put the final locknut to secure. Done.
Doing it that way, makes it very clean and secure. Changing/removing the plate is as easy as removing the lockwasher that is holding it on, and the screws will be held in place.
1.Make 2 holes for the screws to hold the plate
2.Use some machine screws with washers. Put them on the inside of the bumper sticking out..
3.Then on the outside, put a lockwasher and nut to secure them. Make sure you have enough length left on the screw.
4. you will put the plate on.
5. put the final locknut to secure. Done.
Doing it that way, makes it very clean and secure. Changing/removing the plate is as easy as removing the lockwasher that is holding it on, and the screws will be held in place.
Thread
Thread Starter
Forum
Replies
Last Post