I know there are tons of rebuild videos out there that cover rebuilding the keg, but are there any out there that starts with removing the engine from the car and then putting the thing back in?

 

Not that I'm aware of, but I've not seen them all. The video focuses on the engine rebuild, not so much on removal/install. I'm assuming that's because there are manuals out there that explain that anyway.

 

Removing and installing is pretty straight forward. Take off the upper intake and fuel rails, fuel lines, heater hoses, wiring harness, remove oil cooler lines, remove rad hoses, unbolt trans and engine mounts, pull it.

 

I bought one years ago by Bruce Turrentine called '13B Engine Remove & Replace'. Its not the same as the rebuild video. Its useful but you really don't need it. He removes the engine w/o the transmission.

 

http://foxed.ca/index.php?page=rx7manual#secondgen