2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

rebuild dies at low idle, wont stay running

Thread Tools
 
Search this Thread
 
Old 08-15-09, 10:14 PM
  #1  
One piece at a time

Thread Starter
iTrader: (2)
 
marcinband's Avatar
 
Join Date: Mar 2005
Location: Wisconsin
Posts: 90
Likes: 0
Received 0 Likes on 0 Posts
rebuild dies at low idle, wont stay running

I have about 100 miles on my rebuild 1986 13b. I Took it for a short drive after nothing but the best performance over the past day. On the way home it would not idle without dying suddenly. Now it will not start. It just climbs around 500 rpm for a few moments, then dies.
Old 08-15-09, 10:21 PM
  #2  
rotorhead

iTrader: (3)
 
arghx's Avatar
 
Join Date: Aug 2004
Location: cold
Posts: 16,182
Received 429 Likes on 263 Posts
check for vacuum leaks

also, on a new rebuild it's best to set the idle to 1000+ rpm for a little while at least.
Old 08-16-09, 11:47 AM
  #3  
One piece at a time

Thread Starter
iTrader: (2)
 
marcinband's Avatar
 
Join Date: Mar 2005
Location: Wisconsin
Posts: 90
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by arghx
check for vacuum leaks

also, on a new rebuild it's best to set the idle to 1000+ rpm for a little while at least.
Turns out the air intake worked its way loose. Strange.

Thanks for the reply though.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
alphawolff
1st Generation Specific (1979-1985)
17
11-17-15 05:57 PM
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM
rkhanso
2nd Generation Specific (1986-1992)
1
08-13-15 11:40 AM



Quick Reply: rebuild dies at low idle, wont stay running



All times are GMT -5. The time now is 08:15 PM.