rear whindshield wiper doesn't work at all
rear whindshield wiper doesn't work at all
I bought the car in this condition... i was told that it needs some kind of **** to make it work but they supposedly don't make em nemore?
can neone drop sum knowledge on me?
can neone drop sum knowledge on me?
If the rear washer motor runs then the fuse is good. More likely than not,
its the relay inside the cluster switch (just fixed this same problem on my
90 GXL). Get a new switch or rebuild yours. The only **** it needs to work
again is a bit of $$ - lol.
-Henrik
its the relay inside the cluster switch (just fixed this same problem on my
90 GXL). Get a new switch or rebuild yours. The only **** it needs to work
again is a bit of $$ - lol.
-Henrik
I've got a similar problem, but the rear wipers seem to work intermittently (no particular pattern). Cleaning the contacts, which separate when you open the rear hatch, seems to help...
Anyone know what voltage you are supposed to get at the rear wiper? I get about 12vdc with it in the ON position and it cycles about 1.75vdc with it in the Intermittent position....My rear wiper no worky though
I assume the motor is bad but enlighten me please.
I assume the motor is bad but enlighten me please.
Trending Topics
Ok, so now my windscreen wiper doesn't work in intermittent anymore either...
Is there anywhere else that it's possible to get the relays other than from Mazdamark and Mazda? I've tried getting in contact with them, but judging from the lack of resonse, I'm guessing that they're not interested in shipping to the other side of the world
Anyone have any other solutions? I was thinking of pulling the relays apart, cleaning the contacts and sealing them using epoxy glue... Is that likely to help in the long run?
Cheers,
- TT
Is there anywhere else that it's possible to get the relays other than from Mazdamark and Mazda? I've tried getting in contact with them, but judging from the lack of resonse, I'm guessing that they're not interested in shipping to the other side of the world
Anyone have any other solutions? I was thinking of pulling the relays apart, cleaning the contacts and sealing them using epoxy glue... Is that likely to help in the long run?
Cheers,
- TT
Thread
Thread Starter
Forum
Replies
Last Post
Frisky Arab
2nd Generation Specific (1986-1992)
13
Aug 18, 2015 05:30 PM




