rear hps hawk pads fittment(Anyone using these please look)
05-03-05, 09:13 PM
#1
Rexistered User
Thread Starter
iTrader: (8)
Join Date: Feb 2004
Location: San Diego, CA
Posts: 660
Likes: 0
Received 0 Likes
on
0 Posts
rear hps hawk pads fittment(Anyone using these please look)
I am currently doing break work as seen herehttps://www.rx7club.com/showthread.php?t=413517
But A new proble has become of it. The hps hawk pads just don't fit in the rear very well, I had to take two of the metal clips out just to fit them in the pads spot/hole. Who is using these, and have you done anything to make them fit with everything? I was thinking of taking them to a grinder just a smidge...later
But A new proble has become of it. The hps hawk pads just don't fit in the rear very well, I had to take two of the metal clips out just to fit them in the pads spot/hole. Who is using these, and have you done anything to make them fit with everything? I was thinking of taking them to a grinder just a smidge...later
Thread
Thread Starter
Forum
Replies
Last Post
diabolical1
2nd Generation Specific (1986-1992)
30
01-30-16 05:50 AM