RE: 1988 RX-7 Convertible alternator pulley
#1
Junior Member
Thread Starter
Join Date: Jul 2003
Location: Las Vegas
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
RE: 1988 RX-7 Convertible alternator pulley
Hello,
I have a question regarding an alternator pulley for my RX-7
Convertible.
I installed the newer, higher amp 1993 alternator and fabricated the
older (2 half) pulley. The only problem with this is that it vibrates at the higher rev's.
I need to find a pulley that will mount to this alternator and allow
enough room for the nut. I'm not necessarily looking for an under drive pulley,
just something to replace this one.
Do you have any solutions?
Thanks!
Ok, I know there are a lot of people doing this and there must be a solution?
I have a question regarding an alternator pulley for my RX-7
Convertible.
I installed the newer, higher amp 1993 alternator and fabricated the
older (2 half) pulley. The only problem with this is that it vibrates at the higher rev's.
I need to find a pulley that will mount to this alternator and allow
enough room for the nut. I'm not necessarily looking for an under drive pulley,
just something to replace this one.
Do you have any solutions?
Thanks!
Ok, I know there are a lot of people doing this and there must be a solution?
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 11:02 PM