RC Injector Interference
#1
(Terraplane)
Thread Starter
RC Injector Interference
My 750cc RC injectors don't fit in my 1988 TII AE.
The body of the injector hits the cast web between the injector ports of the primaries. Anyone else had this problem? It looks like I can grind the casting down to clear the body, just need some input to see if this is the right track.
I was going to use the injector grommets from the stock injectors since they are relatively new but they are stretched from fitting over the pintle cap of the stock units. Do new grommets have a better I.D. fit on the RC injectors?
The body of the injector hits the cast web between the injector ports of the primaries. Anyone else had this problem? It looks like I can grind the casting down to clear the body, just need some input to see if this is the right track.
I was going to use the injector grommets from the stock injectors since they are relatively new but they are stretched from fitting over the pintle cap of the stock units. Do new grommets have a better I.D. fit on the RC injectors?
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM