Anybody have this? I was planning to use this and the pre-silencer and then bolt it up to my Apexi N1. I know I would need flange modification, but otherwise would this work?

 

Also, does the downpipe bolt up to the stock main cat?

 

I don't know what side your current pipe is running to the N1 muffler, but don't mix 3" with 2.25 or 2.5". You will always have exhaust leaks.

I know the 2.5" RB downpipe is 3" too short to bolt on the stock main cat, but the REV TII 3" uses a completely different presilencer. I doubt it'll line up though, and even if it did, the stock cat has 2.25" pipe.

 

The N1 starts at 70mm (2.75"~) and the REVTII is 80mm (3"~). The N1 replaced the factory y-pipe, so maybe with the presilencer it'll work.

Maybe my best bet is getting the RevTII DP then getting an exhaust shop to custom make a mid-pipe for in between the down pipe and then N1. Like 80mm with an 80mm->70mm flange.