Quick question about essentric shaft
#1
Full Member
Thread Starter
Join Date: Mar 2001
Location: bradenton, fl usa
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
Quick question about essentric shaft
what is the thread size of the essentric shaft on the flywheel side? not the size of the flywheel nut, but the actual size of the threads on the essentric shaft where the flywheel bolts on.
anyone know?
thanks
anyone know?
thanks
#3
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
ERROR. Sorry 'bout the error. The pitch is 1.5, but I lent out my mic to my brother . Maybe tomorrow. EDIT: This is'nt what you asked for, but just in case you need one http://www.mazdatrix.com/b5.htm
Last edited by HAILERS; 12-23-01 at 08:36 PM.
#5
Full Member
Thread Starter
Join Date: Mar 2001
Location: bradenton, fl usa
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
well, when i did a clutch job a little over a year ago, i put the flywheel nut back on with loctite and an impact wrench just like everyones says to do. well, i pulled my motor out today and tried to get the flywheel nut off again. it took forever to get that thing off with an impact wrench! it wasnt just the intial to break the nut loose either, the whole way off the esecntric shaft the nut was just barely turing with an impact gun on it! at any rate, the threads are just slightly damaged, nothing that cant be fixed. i just wanted to get a file of the right size to clean them up a little bit.