quick dumb 13bt question

Reply Subscribe

Thread Tools

Search this Thread

Nov 21, 2001 | 01:07 PM

IlAkiralI

Thread Starter

Full Member

Joined: Mar 2001

Posts: 100

Likes: 0

From: 817 tx

quick dumb 13bt question

will the upper and lower ( isnt there an upper and lower ) intake manifold from a 13brew fit on the 13bt if so with what mods if any

T.I.A

Nov 21, 2001 | 01:23 PM

zyounker

root

Joined: Mar 2001

Posts: 1,200

Likes: 0

From: Phoenix, AZ

You can use the upper intake & TB from an FD... You have to do some port matching & round out 2 of the bolt holes on the FD upper manifold...

Do a search on this. it was just talked about a week ago...

Nov 21, 2001 | 01:29 PM

IlAkiralI

Thread Starter

Full Member

Joined: Mar 2001

Posts: 100

Likes: 0

From: 817 tx

i did a search couldnt come up with anything can you point in the right direction thanks

Nov 21, 2001 | 01:44 PM

zyounker

root

Joined: Mar 2001

Posts: 1,200

Likes: 0

From: Phoenix, AZ

https://www.rx7club.com/vforums/show...n+upper+intake

https://www.rx7club.com/vforums/images/spacer.gif

https://www.rx7club.com/vforums/show...n+upper+intake

Here you go....

Nov 21, 2001 | 04:34 PM

RX-7 GT

HyperREV.com

Joined: Mar 2001

Posts: 1,162

Likes: 0

From: Oregon

hey zyounker. did you do it on a series 4 or 5? i forgot

also if its a series 4 are you still using pre-mix? cause i heard the rod from the omp is in the way of the fd manifold or some junk?

Nov 22, 2001 | 08:34 PM

zyounker

root

Joined: Mar 2001

Posts: 1,200

Likes: 0

From: Phoenix, AZ

You will not be able to use the metering rod with the 3rd gen intake.. I will probably run premix. My friend runs a aviation metering pump that is RPM dependant.. It seems to work well..

-Zach