Real quick background... i decided to rip out my airbox on my 87TII, and see what I could do with making an air box and using a K&N cone filter I have laying around. So, I noticed that I'm going to need a flange to connect a rectangular MAF to a circular cone filter. Is there a flange that someone might have that I can do this with, or do I have to go through the measurements and have one made up here at work? Also, if someone has one, but doesn't want to sell it, could I get measurements? I'm basically just putting this project off till I find out what's going on with that one flange, but then I'll be doing a TID and Intake all at the same time. Thanks for the info in advance.

 

http://www.hksusa.com/products/?id=639

 

I checked that place and now I'm trying to find someone to buy that stupid thing from. What a pain in the ***... I should've just measured and made one now. I've got nothing better to do than post about a flange for my AFM, so I'm sure I could find time to run a rectangle and attach a pipe. Thanks for the link though

 

I bought one from K2RD, but they took them off their site for some reason.

 

Does Passen Motorsport spread from Ohio into PA?

If not they may be able to ship, check their website:
www.passenmotorsport.com

 

Actually it was www.passenmotorsports.com, but the site isn't responding.

 

holy *****!! I just hit Refresh on this page and I got a ton of responses in that time. In any case, I just emailed one place and i cut and pasted so I'll send one to Passen too. Thanks.