Questions regarding, starting, stoping, and starting the car again.
#1
Full Member
Thread Starter
Join Date: Mar 2004
Location: Chester, Virginia
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
Questions regarding, starting, stoping, and starting the car again.
Hey i have an 1988 t2 that i rebuild myself, i'v removed all emissions and have block off plates. I'v removed oil metering pump, and am running remix. I have a problem with starting, stoping, and starting that car again. In the morning after i have let the car sit over night it will start up fine. If i drive it around for a little while, then let it sit so it goes back to normal operating tempture then turn it off, i can restart the car for a few hours or so. Im positive its not flooding, cause i turn the car off by a fuel cut switch. I'm thinking it may be some sensor malfuntioning, but any thoughts on my problem would be very much appreciated.
#4
Full Member
Thread Starter
Join Date: Mar 2004
Location: Chester, Virginia
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
compression is around 95 or so, its a rebuild with non-resurfaced houseings, and its only got 50 miles or so on it.
and no im not leaking coolant into the combustion area, my spark plugs are dry when i pull them to see if any gas has flooded them.
I think it may be a sensor im missing or not connected. there are a few that i don't have connected. im just not all too sure which and where.
and no im not leaking coolant into the combustion area, my spark plugs are dry when i pull them to see if any gas has flooded them.
I think it may be a sensor im missing or not connected. there are a few that i don't have connected. im just not all too sure which and where.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
josef 91 vert
2nd Generation Specific (1986-1992)
23
09-03-15 11:20 AM
smikels
2nd Generation Specific (1986-1992)
3
08-18-15 01:26 PM