Question for all
#1
Junior Member
Thread Starter
Join Date: Apr 2009
Location: South Florida
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
Question for all
I have a twin turbo rotary 13bre i want to throw a single turbo in it can anyone give me some advise on what size to put on my motor
#2
Rotorhead
Join Date: Feb 2001
Location: Charlottesville, Virginia, USA
Posts: 9,136
Likes: 0
Received 39 Likes
on
33 Posts
What is the purpose of the car? For example, will it be a daily driver, and/or will it drag race, road race, or autocross?
Also, I am a bit concerned that you are asking a very basic question for an engine that is a royal pain in the rear to install and run in the FC RX-7.
Also, I am a bit concerned that you are asking a very basic question for an engine that is a royal pain in the rear to install and run in the FC RX-7.
#5
Wish I could bring some turbo ideas to this table but my FD has the twins on her but no longer sequential. You're going to get a lot more ideas in the FD forum I believe.
#6
Rotorhead
Join Date: Feb 2001
Location: Charlottesville, Virginia, USA
Posts: 9,136
Likes: 0
Received 39 Likes
on
33 Posts
A GT35R or T62 ball bearing turbo would work pretty well for that. We also have a Single Turbo subforum on this site:
https://www.rx7club.com/forumdisplay...sprune=-1&f=23
https://www.rx7club.com/forumdisplay...sprune=-1&f=23
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM