Question about Intrax springs
#1
Rotary Enthusiast
Thread Starter
Join Date: May 2001
Location: AL
Posts: 770
Likes: 0
Received 0 Likes
on
0 Posts
Question about Intrax springs
Anybody use thes autocrossing and what do you think of them? What did you do to get the alignment back to a usable spec like rear camber adjustor or camber plates on the front. Any idea on the spring rates for these.
I got the complete strut assemblies and coil springs for $25 this weekend at a local junk yard. The struts are KYB Gas-a-Just. Everything was dirty but still in good shape. They cleaned up nicely.
I got the complete strut assemblies and coil springs for $25 this weekend at a local junk yard. The struts are KYB Gas-a-Just. Everything was dirty but still in good shape. They cleaned up nicely.
#5
Rotary Enthusiast
Thread Starter
Join Date: May 2001
Location: AL
Posts: 770
Likes: 0
Received 0 Likes
on
0 Posts
On a trailered autocross car I can deal with them being stiff. I'll eventually get the Ground Control setup but thought I could live with the KYB's and Intrax pieces till then. Hopefully its an improvement over the stock pieces.
Thread
Thread Starter
Forum
Replies
Last Post
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM