I will be replacing my pulsation damper with a banjo bolt from Earl's(807691). I have searched for information regarding the crush washers that I will need to complete the installation. Here is my question:

Can I use the two washers that come with the above fitting or should I buy new ones?

Thanks.

 

Have you tried the search function to find RETed's page about this???

 

Yes I have... as stated in my post....

this information is not in RETed's post... or any other posts....

 

Check out this post..

https://www.rx7club.com/forum/showth...hreadid=114684

I would recomend replaceing the crush washers, I did. They are cheap if you buy them seperate .. and the right ones come with the Earl's part I ordered. (see above thread)