My girlfriends brother-in-law came across an 87 RX7 (non turbo) that he purchased. It did not run when purchased. We have played with it, and have not been able to get it to start under its own power. We were able to get it started by towing it behind a truck and basically giving it a high speed push start. It would run fine after this "push start" if you kept the RPM's above 3000. If we let the RPMs drop it would stall out before it would even come close to reaching idle speed.

We have not tried the unflooding trick, since I just learned about it today, but I will certainly try that tonight. Does this sound typical of a flooded rotary motor?

Thanks in advance...

Bryan

 

mine was diong the exact same thing happen to me i had to tow my car because it wouldnt start regular so i adjusted the throttle then push started it with my friends car and drove it for 10 min, then it idled but it idled high(1700rpm) then i went from there

 

Have you tried the ATF trick then roll started it? Also, are you letting it warm up after you start - VERY IMPORTANT!!! - Here is a link

http://www.mazspeed.com/atf.htm