Can I run the vac line for the pressure sensor to the stock location for the vac line of the bov, and then run the bov vac line to where the vac line for the pressure sensor went to on the ACV?

O and both of these lines will be solo with nothing tapped into them, the only reason for me doing this is because i took the acv off and I tapped out the block off plate like nz did, and the vac nipple i put in is the same size as the one for my bov and i want to run the same size line...

So is it the same amount of vac at both sources?

 

Yes you can do that. That's how mine is, just because I prefered the two lines to run parallel rather than crossing each other. **** I know...

The two nipples are both fed from one of the primary intake runners at about the same point, so they should give exactly the same reading.