Pressure/Boost sensor?
Thread Starter
It LIVES!!!!
Joined: Sep 2006
Posts: 278
Likes: 0
From: Arlington, TX
Pressure/Boost sensor?
Would anyone know how to test the little black "pressure" sensor on the passenger shock tower... I asked a question about my secondary injectors earlier... The did not seem to work... I have since connected them directly to the battery and they are fine... I just need to know how to check the pressure sensor or what my next step would be... Pleease... Any help would be greatly appreciated...
Originally Posted by spot_skater
I KNOW it's in the FSM. Check the FAQ at the top. But You're gonna have to get a vacuum gauge, and check the resistance values (IIRC) after applying "x" amount of vacuum to the sensor.
Originally Posted by C.A.R
Sorry... I meant to say that I have a 1989 RX7 - Stock... No turbo.. .
FSM
........
HAILERS
Joined: May 2001
Posts: 20,563
Likes: 27
From: FORT WORTH, TEXAS,USA
Go out to your car and turn the key to ON. Now get a meter and see what the output voltage is from the sensor and write that down. Now start the engine and idle it fully hot at approx 750 rpm and write that down. Submit the figures on this thread and we'll see what we can do with just those figures. We ought to be able to have clue from those figures if the sensor is half *** good/bad.
Measure the output voltage AT the ECU with the ECU's plugs connected .
Measure the output voltage AT the ECU with the ECU's plugs connected .
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
Adaptronic Engine Mgmt - AUS
5
Sep 28, 2015 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
Sep 24, 2015 10:57 PM
rotor_veux
2nd Generation Specific (1986-1992)
7
Sep 19, 2015 07:13 PM