2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Power Windows

Thread Tools
 
Search this Thread
 
Old Jul 29, 2004 | 08:01 AM
  #1  
jimmyjimmy's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Jul 2004
Posts: 6
Likes: 0
From: Sydney
Power Windows

Any help would be greatly appreciated.

S4 power windows will function for a short period of time after ignition is turned on. They stop working after a short period of time. Turning the car off, then restarting will allow the windows to function again.

Drivers door switches and ignition barrel have been cleaned and seem to be working fine.

This is an on going and annoying problem. Thank you
Reply
Old Jul 29, 2004 | 09:13 AM
  #2  
jimmyv13's Avatar
Round&Round not Up&Down
Tenured Member 15 Years
 
Joined: Aug 2001
Posts: 2,805
Likes: 0
From: West Bloomfield, MI
Did you grease the window slide components? Something might be binding up there and not allowing the window to move freely.
Reply
Old Jul 29, 2004 | 11:20 AM
  #3  
nashman69g's Avatar
Boost Addict
Tenured Member 20 Years
iTrader: (3)
 
Joined: Nov 2001
Posts: 1,898
Likes: 13
From: Metairie, LA near new orleans
check for loose connections...
Reply
Old Jul 29, 2004 | 05:45 PM
  #4  
Icemark's Avatar
Former Moderator. RIP Icemark.
 
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
I would also check for other things not working when the windows go out (for example does the AAS still work, or the turn signals... both are on the same ignition wire).

If they do, then that rules it out to the fuse box or later in the system (so your ignition switch would still be good). If they don't then you have a bad ignition switch.
Reply
Old Jul 30, 2004 | 06:50 AM
  #5  
jimmyjimmy's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Jul 2004
Posts: 6
Likes: 0
From: Sydney
Thanks for the replies

Only the windows stop working everything else is fine.

Should I change the ignition barrel??
Reply
Old Jul 30, 2004 | 10:23 AM
  #6  
Icemark's Avatar
Former Moderator. RIP Icemark.
 
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
Originally Posted by jimmyjimmy
Only the windows stop working everything else is fine.

Should I change the ignition barrel??
If eveything else works, then that rules it out to the fuse box or later in the system (so your ignition switch would still be good). If they don't then you have a bad ignition switch.
...
Reply




All times are GMT -5. The time now is 08:52 AM.