Plugs--Where do they go???
01-19-04, 03:00 PM
#2
Rotary Enthusiast
iTrader: (9)
Join Date: Jun 2003
Location: west
Posts: 1,191
Likes: 0
Received 0 Likes
on
0 Posts
The yellow is for the water temp gauge. There should be a single pin sticking out next to the heater hose below the oil filter.
The round connector is your ECU ground (very important). Make sure you connect that to a clean ground on the block. That should have been bolted to the top of your engine block same bolt for the intercooler bracket.
The round connector is your ECU ground (very important). Make sure you connect that to a clean ground on the block. That should have been bolted to the top of your engine block same bolt for the intercooler bracket.