piolt bearing adapter???
#1
Junior Member
Thread Starter
Join Date: Nov 2002
Location: cali
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
piolt bearing adapter???
my brothers car rx7 1989 gxl the clutch was acting funny so i took it apart, and i seen the piolt bearing was just destroyed the little needles are everywhere, and i was using the haynes manuel as a referance, and it says for the piolt bearing that i need a slide hammer and a special adapter found at auto parts stores, does anyone know what the special adatper is? any help would be very nice...thanks
-Jeremy
-Jeremy
#4
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Originally posted by SeXyReX7
i used a dremel with a carbide bit, i cut that sucker out. but i'm sure that tool would be a lot easier!
i used a dremel with a carbide bit, i cut that sucker out. but i'm sure that tool would be a lot easier!
Save yourself an hour of hell and possible damage to the eccentric shaft and just get the tool.
#6
Full Member
Join Date: Aug 2002
Location: Johnson City, TN.
Posts: 195
Likes: 0
Received 0 Likes
on
0 Posts
Yeah I also went to Autozone and borrowed the pilot bearing puller and slide hammer it was little to big to fit in the bearing so I filed the end of the puller just a bit they never noticed it worked just fine
Thread
Thread Starter
Forum
Replies
Last Post
joel(PA)
Group Buy & Product Dev. FD RX-7
8
10-04-15 06:07 PM