benny_rx_blanco

Hello,
I just got this HKS super BOV and was wondering what I connect those lines to. I know the connector that came with it in the pic shows where on the BOV those two go, but what about the other one?

any info would be great...
Peace,
Benny

benny_rx_blanco

here it is

Ridge Tech

its a T fitting so you can tap into a vacume line. Find a vacume line comming off the TB and tap it in. The best one to use is the one on the back side near the firewall at the bottom. It is located at such a place on the intake that is will get both vacume and boost. The other fittings will only give you boost (more or less).

Chris

Poindexter10thae

iTrader: (2)

I have the Exact same BOV. the nipple on the back of the bov is where the BOV gets its signal from, this can be T'd in with the boost sensor vaccum line, or with the wastegate actuator. the other nipple is just vent, can go just about anywhere or be plugged

benny_rx_blanco

So the black back nipple is the one to ''T'' into the boost sensor line? Does that matter if I connect the two like the rubber hose looks like it did and the end peice is to be ''T'' in?
Benny

benny_rx_blanco

N E 1 have pics?

Poindexter10thae

iTrader: (2)

That'll work

RX7withNitrous

is that what the old hks bov looks like?

benny_rx_blanco

Can any one post a pic of their BOV in their FC .

Poindexter10thae

iTrader: (2)

I have to resize the pic of mine, i will post it tonight

benny_rx_blanco

also can someone link me to some good fc video's, got DSL now and want to put the **** to use.

Lata's,
ben