parallel fuel ine setup question
Thread Starter
Joined: Dec 2007
Posts: 1,714
Likes: 2
From: Ortonville, MI
parallel fuel ine setup question
http://www.fc3spro.com/TECH/MODS/FUEL/pararail.jpg
I was wanting to du that setup except i was looking to do it in -8
The problem is that I can find a -8 to 14X1.5 fitting but I cannot find a -8 to 12X1.25 fitting.
Would it be ok to run -6 line coming out of the fuel rails, since the pressure and volumetric flowrate is less once it is distributed to the injectors. I know return lines are usually smaller.
Any ideas? Or know where I can find that second fitting in a -8.
I was wanting to du that setup except i was looking to do it in -8
The problem is that I can find a -8 to 14X1.5 fitting but I cannot find a -8 to 12X1.25 fitting.
Would it be ok to run -6 line coming out of the fuel rails, since the pressure and volumetric flowrate is less once it is distributed to the injectors. I know return lines are usually smaller.
Any ideas? Or know where I can find that second fitting in a -8.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM