well here is a couple of pics of the drivers door frame,,for those that have been following this,,this is probably nothing new but for those looking to restore their 2nd gens these are good pics for ya





Now i gotta figure out where i am going to put the door to paint the inside of it

 

Looks good! I ended up using a table to paint the inside of my doors, just laid it out on top and spun it around. Then again, not concourse quality paintwork either G'luck

PaulC

 

that is kinda what i had in mind,,maybe find a crappy blanket to lay it on so i don't dent up the outside

 

What kind of paint are you using?
I am trying to start putting stuff together so that I'll have my restoration under way early this summer right when I get home from college.
I'll be ordering the engine very soon, but still thinking about what route to go with paint.

Yours seems to be going well though!

 

Oh, I can give you one tip. Clean the inside of the doors REAL good, mine fisheyed badly when I painted them. Didn't have a problem anywhere but the insides of the doors.

PaulC

 

i use a body shop grade wax and grease remover and i also add fisheye addative to my paint too

as for the paint i am using PPG's Omni line paint,,and Omni high solid clear coat

it is a fairly inexpensive paint,,but turns out very well

you could go cheaper yet,,there are some dupont paints that are alot cheaper but you can tell they are cheap by their results,,,i have been using Omni for years and i love it