npr ic sizes?
#1
skookum
Thread Starter
iTrader: (3)
Join Date: Jul 2007
Location: Fishersville, VA
Posts: 335
Likes: 0
Received 0 Likes
on
0 Posts
npr ic sizes?
looking around and i couldnt find which npr ic people where using. i know there are three different sizes and i have have some on ebay but i believe they are the large ones.
real question is which ones fit best (minimal cutting) in our fc's
real question is which ones fit best (minimal cutting) in our fc's
#2
RE_p Rotors
iTrader: (7)
Join Date: Dec 2006
Location: Newport News/Fredericksburg
Posts: 950
Likes: 0
Received 0 Likes
on
0 Posts
thought there is only one size intercooler and piping from the truck available. Im using it on my t2. 2.5 piping 2.5in core had to extend the piping about 3 inches on either side but I wanted the IC out as much as possible to the front of the car. Good cooling and minimal drop especially for the price of it.
#3
skookum
Thread Starter
iTrader: (3)
Join Date: Jul 2007
Location: Fishersville, VA
Posts: 335
Likes: 0
Received 0 Likes
on
0 Posts
http://motors.shop.ebay.com/i.html?_...sacat=0&bkBtn=
theres one size and i think it the medium but i am not sure. i have been doing alot of looking around and can't figure out which one fits properly. do you know the deminsions of yours?
theres one size and i think it the medium but i am not sure. i have been doing alot of looking around and can't figure out which one fits properly. do you know the deminsions of yours?
#5
Senior Member
That top NPR intercooler in that ebay listing is what everyone on this forum calls the "large NPR", it's a 14 1/2 inch" tall core. But there is taller core I've seen with a "16 inch" height. I'm assuming it must be off the latest generation of NPR trucks as it looks almost identical to the 14.5" tall core one except for the bottom mounting holes are on the bottom side of the IC tanks and obviously it looks slightly taller. That one might be a tough go to stuff into the front of an FC unless you mount it directly in front of the Rad and reposition and reangle the rad back a couple of inches ,that's why I mention it.
#6
skookum
Thread Starter
iTrader: (3)
Join Date: Jul 2007
Location: Fishersville, VA
Posts: 335
Likes: 0
Received 0 Likes
on
0 Posts
thats actually my plan to begin with was to move the rad a bit forward and cut a bit out of the sheet metal for the pipes. its going into my track car so the cutting doesnt bother me, and the ac is already removed so thats taken car of. thanks for the info
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM