Does Any body have pics of a small NPR mounted on their FC? Im about to get one and just wanted to see how it looks mounted up in front, thx alot.



-Justin

 

npr? national public radio

 

yes does anyone have pics of national public radio mounted on there fc?!?

haha my bad i meant NPR intercooler...

 

Some shots of my horizontal mount NPR core.

 

Hmm, that looks very nice.
Couple questions, if I may
- Where did you get it?
- What components did you use?
- How much did it set you back?

 

Thats truely beautiful. i have that thread saved on my comp. I wud really like to go horizontal mount since i have so much room in my engine bay and weld on some custom endtanks, ur cars setup is pretty much my inspiration for hmic. Where about california are u? SoCal or norcal?

 

Hey blue, do u have the URL to the thread that had all those pics in it. I searched for it, but couldn't find it.
-Hijacking over

 

j200pruf-
heres one
https://www.rx7club.com/forum/showth...hreadid=145822

damn that hmic is so dope haha got me lookin at it all over again, i wud attempt but dontknow how far i would get haha. Anyone have any more pics of an npr on fc?

 

Original post

https://www.rx7club.com/forum/showth...hreadid=145604

Hmm, that looks very nice.
Couple questions, if I may
- Where did you get it?
- What components did you use?
- How much did it set you back?

NPR IC and all piping was from scrapyard, 3rd gen UIM and '89 TII LIM were from forum members. I think all those parts together were under $500.

 

Blue TII-

What kind of hood are you using? And where did you get all of those cf peices that you are using through out your engine bay? And what did you use to seal off and foam in the seperate duct passages?

 

Using the stock TII hood still. Was going to use my NA hood and reverse vent, but Dltreezan is going to make one of his fiberglass vented hoods for me. I am surprised how well the set-up is working even venting out the trans tunnel like an FMIC instead of out of the hood.

www.carbontrix for all my CF sheet and hood vent.

I used 22 guage stainless (it has very good heat rejection properties) to divide the stock opening/duct for oil cooler and radiator and the new bumper opening/duct for the HMIC. This sheetmetal curves up from the bumper (at top of stock bumper opening) to the top of the radiator and so forms the top of the radiator duct and the bottom of the HMIC duct. Yep, everything is sealed up w/ foam.

 

Wow thats very cool. Thanks for the information.