Not turning over after slave replacement
#1
Backyard Mechanic
Thread Starter
Not turning over after slave replacement
Replaced my clutch slave cylinder the other day. Drove the car once and the next morning I went out to start it, I herd a loud clicking noise from behind the UIM.
Tried it a few more times and now I get nothing.
Car has a brand new starter, all wires are hooked up correctly and is grounded to the starter bolt.
I did the jumper trick on the clutch safety switch down by the clutch and still nothing.
I have lights, gauges and I can hear the fuel pump come on so I don't think it could be a "under the hood" fuse.
Car is a 1990 na
Anyone got some advice on what I should check out next?
Tried it a few more times and now I get nothing.
Car has a brand new starter, all wires are hooked up correctly and is grounded to the starter bolt.
I did the jumper trick on the clutch safety switch down by the clutch and still nothing.
I have lights, gauges and I can hear the fuel pump come on so I don't think it could be a "under the hood" fuse.
Car is a 1990 na
Anyone got some advice on what I should check out next?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM