2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Noob question about seats

Thread Tools
 
Search this Thread
 
Old Dec 19, 2004 | 07:24 PM
  #1  
autorx7's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Mar 2004
Posts: 24
Likes: 0
From: sf
Noob question about seats

I can't install a passenger side S5 seat! Is it just me, or is it supposed to be this hard? I can't line up the left rear hole in place!
Reply
Old Dec 20, 2004 | 01:19 AM
  #2  
LookThatsMe's Avatar
Rotary Enthusiast
Tenured Member 10 Years
 
Joined: Apr 2004
Posts: 841
Likes: 0
From: NJ
well lossen up all the bolts so you could still move the seat around and it should slide in... if that dont work check if you rails are straight
Reply
Old Dec 20, 2004 | 01:29 AM
  #3  
rs_1101's Avatar
Rotary Enthusiast
Tenured Member 10 Years
 
Joined: May 2004
Posts: 1,088
Likes: 0
From: OC
lol i had same problem... loosen all the bolts and have a hammer ready.
Reply
Old Dec 20, 2004 | 11:02 AM
  #4  
Icemark's Avatar
Former Moderator. RIP Icemark.
 
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
if you have a single bolt not lining up, try loosening all the bolts, holding up ther slider release (the handle in the front of the seat to adjust the forward back ward position of the entire seat) the move the seat a little side to side.

The brackets will line right up.
Reply




All times are GMT -5. The time now is 04:35 AM.