no start on tii swap
no start on tii swap
i have an 86 na car with an s4 tii engine. i have installed every part of the engine management system that is needed for a turbo car(boost sensor, afm, + ecu exhaust, fmic, etc). I have a no start, however, if i bypass the turbo fmic + afm(afm still hooked up electrically) , it will run a little bit, but will not idle and barely runs(if i dont keep the starter goin, it will die out soon after it starts) anyone have any thoughts for me? I also have good compression.
did u put the afm in backwards? your fmic shouldnt ahve anything to do with it not runnning should it? clean injectors? start at ground zero and work your way back till u find the problem i would say
Check for error codes if you haven't already done it.
http://www.teamfc3s.org/info/article...odes/main.html
http://www.teamfc3s.org/info/article...odes/main.html
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
The Shaolin
2nd Generation Specific (1986-1992)
9
Sep 14, 2015 07:50 PM
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM



