OK.. now I'm pissed.. the engine is finally in and done, 8 hours later. Everything is hooked up. Won't start- I just assuming it's flooded.
I find out that I'm not getting any spark at all!
The CAS is hooked up, what the hell could be wrong??


My damn clutch pedal is sitting on the floor too... pretty great. Now I have to check the master and slave cylinders.

There isn't any possility that I could have knocked off the pilot bearing or anything by installing the engine is there?
Thanks.

 

my guess for the clutch problem is the master cylinder is shot and needs replacing.

 

Ok... got spark.
I didn't know ignition cut out when the EGI fuse is removed. Oh well.

I guess it's just flooding, I've got fuel, I've got spark, it'll probably just take a few times of removing the plugs and drying them, and cranking the engine a few times to get it to catch. Good thing I have a battery charger!

I still don't know about the clutch.....There's some sludge of unknown orgin in the resevoir... maybe the cylinder is stuck.