new owner with gasket problems.....
Thread Starter
Full Member
Joined: Apr 2003
Posts: 59
Likes: 0
From: Kitchener ON, Canada
new owner with gasket problems.....
ok, HI!
glad to be here, my name is jeff, bought a 1987 rx-7 rx non turbo, ran great, drove it about 400 miles to my home, at the end of the trip, my add coolant light came on and at the stoplight i had a LOT of smoke, so i got home and opened the hood, coolant was everywhere. so the leak turned out to be between the waterpump housing and the engine block.
so i took it all off and redid the gaskets between the water pump/housing and between the housing/block.
when i took thecar out after leaving it sit for 24 hours, the same gasket blew, housing/block. the other one held, any ideas??
glad to be here, my name is jeff, bought a 1987 rx-7 rx non turbo, ran great, drove it about 400 miles to my home, at the end of the trip, my add coolant light came on and at the stoplight i had a LOT of smoke, so i got home and opened the hood, coolant was everywhere. so the leak turned out to be between the waterpump housing and the engine block.
so i took it all off and redid the gaskets between the water pump/housing and between the housing/block.
when i took thecar out after leaving it sit for 24 hours, the same gasket blew, housing/block. the other one held, any ideas??
Thread Starter
Full Member
Joined: Apr 2003
Posts: 59
Likes: 0
From: Kitchener ON, Canada
so what should i do? take the pump housing to a machine shop? but then what if the warp is on the block. i really need some guidance, as i sold my acura to buy this car.... and now it dont run....
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
alemmons
3rd Generation Specific (1993-2002)
3
Sep 4, 2015 09:34 AM